Marine Bilge & Locker Paint Enamel
Marine Bilge & Locker paint Enamel which provides a tough film with good adhesion, gloss and weathering properties. When fully dry, the coating exhibits good resistance to petrol, paraffin and mineral oil spillage. Semi-gloss & Matt can be used as one coat paints as they contain anti-corrosive products however it is always recomended to use a primer first for the best anti-corosion protection.
Marine Bilge & Locker paint EnamelBrushing / Spraying Enamel Paint is based on a polyurethane enamel resin, suitable for brush, roller and spray applications, to be used as a metal, wood and concrete or brick paint, along with other suitably prepared and primed substrates.
Marine Bilge & Locker paint Enamel Brushing Spraying Enamel paint available in high gloss, semi-gloss and matt. Our matt and semi-gloss finishes, contain anti-corrosive pigments and can be used as a one coat application, to mild steel substrates.
Bilge & Locker paint Enamel Brushing / spraying Paint can be used in many different ways a few variations are on boats, barges, narrowboats, ships, yachts and other maritime equipment.
- Touch Dry in 2-4 Hours
- Overcoat in 12-24 Hours
- Full Dry in 7 Days
- Thinners if required T0001 White Spirit
- Coverage 8-10 squared metres per litre, we cannot be held responsible for the method of application, absorption of substrate or wastage.
- Application by suitable spray application, brush or roller
- Suitable for metal, wood, concrete and other suitably primed substrates
Things to know
- Mix paint well before use and check colour before use.
- Semi-Gloss and Matt finished can be used as a one coat finish to mild steel as they contain anti corrosive pigments.
- For the best anti-corrosion protection to metal use a primer first.
- Make sure substrates are suitably prepared (lightly abraded, degreased and or primed).
- When applying to pre painted substrates ensure existing paint is in good condition and lightly abraded to provide a key for the new coating to provide good intercoat adhesion.
- Temperature will affect drying times but will not prevent curing. We recommend no less than 10 degrees centigrade to ensure no microscopic moisture build up on substrate. 25 degrees centigrade is the optimal temperature.
- Suitable for use on steel, wood, concrete, and other suitably prepared and primed substrates.
- If thinning is required 10% is recommended if brushing, additional thinners may be needed if spraying to achieve good atomisation of the product.
|Mainland Uk||1-3 Days||1, 2.5, 5, 20, 25, 205 & 1000 Litres|